Bolid Signal-10 Manual de usuario descargar pdf (Pagina 34)

INTRUSION&FIRE ALARM ADDRESSABLE 20-LOOP CONTROL DEVICE

doesn’t response to the queries of the net controller which displays the

“FAIL RS485 LINE” message.

If the device has entered the “Device Failed” mode the “Ready” indi-

cator switches in the interrupted mode with high frequency (8Hz).

In case of entering the “Device Failed” mode it is necessary to update

the microcontroller embedded software. To do this:

1. Send the query-by-mail to the NPV BOLID specifying the true device

version.

2. Receive from the NPV BOLID the "ORION_PROG.EXE" loading pro-

gram and embedding software e-file.

3. Connect the device to the personal computer by means of interface

converter PI-GR or S2000-PI manufactured by NPV BOLID.

4. Run the program "ORION_PROG.EXE" and then switch on the de-

vice power supply.

5. Following the loader directives wait until the embedded software up-

date has been finished. After update has completed the device is to

transit the technical readiness mode.

Table 8: “READY” indicator lights

Device operation mode The indicators behavior

Technical readiness mode Light indicator is off

Operating mode

Indicator is lit in case of being connected

to the net controller, or blinks with the 1

Hz frequency otherwise

“Power Failed” mode

Indicator switches in interrupted mode

with 0,125 s ON and 0,875 s OFF

Diagnostic mode Indicator blinks with the 2 Hz frequency

“Device Failed” mode Indicator blinks with the 8 Hz frequency

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 56 57

Sin comentarios

Bolid Signal-10 Manual de usuario Pagina 34