Bolid Signal-10 Manual de usuario descargar pdf (Pagina 32)

Orion ISS

www.bolid.com 32

For executive programs #1 – #8 (general purpose programs), #11 (ASPT), #12 (Siren), #33 (ASPT-1),

#34 (ASPT-A), #35 (ASPT-A1) in case of breaking an Auxiliary alarm loop (of Type 6) related with an

output, switching this output from other related alarm loops is blocked. If upon the recovering of the

Auxiliary loop the conditions for switching the relay remains then:

− for the executive programs with unlimited activation time (#1, #2, #5, #6) as well as pro-

grams #12 (ASPT) and #33 (ASPT-1) the relay output will be switched again, but

− for the executive programs #3, #4, #7, #8, #34, #35 the output will NOT be switched

Thus, breaking of an Auxiliary alarm loop blocks an execution of the general purpose programs with

unlimited activation time as well as the programs ASPT and ASPT-1, and cancels the execution of the

general purpose programs with a restricted activation time as well as Siren, ASPT-A, ASPT-A1.

NOTE: Local control of relay outputs is more significant than centralized control. That is, if a re-

lay output is related to an alarm loop status in the device settings then remote control

commands of a network controller over RS-485 interface will be ignored.

Centralized Output Control

To enable centralized control for a Signal-10 relay output:

− In alarm loop settings, break an association between the output and any alarm loop of the

device (that is, the Relay … Control parameters for this output must be set OFF for all the

alarm loops of the Signal-10

− In output settings, assign this relay output to any Executive Program with a suitable initial

relay on/off condition

− In the network controller database, assign the output with relevant Orion system partitions

and give a required executive program along with a proper activation time and activation de-

lay.

Table 5. Executive Programs for Relay Outputs

№ Program Description

Initial

Condition

0 Remote Control The relay is controlled only remotely Off

1 Switch On

The relay is switched on if there is an Intrusion

Alarm or Fire Alarm

Off

2 Switch Off

The relay is switched off if there is an Intrusion

Alarm or Fire Alarm

3 Switch On for a Time

The relay is switched on for a specified time if

there is an Intrusion Alarm or Fire Alarm

Off

4 Switch Off for a Time

The relay is switched off for a specified time if

there is an Intrusion Alarm or Fire Alarm

Blink From Off

Condition

The relay is switched on/off once per second if

there is an Intrusion Alarm or Fire Alarm

Off

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 95 96

Comentarios a estos manuales

Sin comentarios

Bolid Signal-10 Manual de usuario Pagina 32

Comentarios a estos manuales