Bolid Signal-10 Manual de usuario descargar pdf (Pagina 84)

Orion ISS

www.bolid.com 84

There are two ways to add keys:

− To read keys from a special file by means of icon, and

− To create new key descriptors by means of icon or <Ins> key pressing

In last case to add a key:

1) Press Add Key button (or <Ins>); the new entry named as ‘New Key’ will appear in the key list

2) Describe the reader which the key being registered will be presented to. To do this specify in the

boxes located below the key list the network address of an Orion system which the reader is con-

nected to as well as the number of the reader if the device has more than one reader.

3) By pressing the

button in the Main Key Code field read the code of the key.

Each key from the key list at Keys tab is assigned to a number of attributes (see Figure 16) which can

be specified or revised:

Key Name (the textual field above the key toolbar)

Tape the textual name (or comment) which will be shown in the key list identifying the key.

Key Type

Specify the Key Type. Select User value if the key is intended to arm/disarm alarm loops of the de-

vice, or Master value if the key is intended for programming new User keys by hardware (see

Electronic Keys section of this Manual).

Key Is Disabled

This switch provides easy key locking/unlocking. When the flag is set the key is disabled. It can be

necessary, for example, if the key is stolen or lost, or should be temporary disused for any reason.

Arm/ Disarm

Define or change the status of the key.

In the Arm string tick the boxes below those loops of the Signal-10 which the key is permitted to arm.

Similarly, and in the Disarm string tick the boxes below those loops of the Signal-10 which the key is

permitted to disarm.

For Master keys the programmed statuses will be inherited by all the User keys which then will be

programmed by hardware using this Master key.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 95 96

Sin comentarios

Bolid Signal-10 Manual de usuario Pagina 84