Bolid Signal-10 Manual de usuario descargar pdf (Pagina 73)

Signal-10 Programming

The network address of the device can also be set or changed by means of network controller tools in

accordance with the Manual for the network controller being in use.

Setting the Response Pause parameter provides using the device within a system with a sophisticat-

ed network topology where long layover can be, for example, while converting RS-485 data into other

interfaces intended for transmission over local area networks, fiber optic channels, or radio channels.

)

To set or change the Response Pause value, select the Device → Set Response Pause

command from the UProg menu.

The current values of the Network Address and Response Pause can be reset to factory (default)

values by pressing the device tamper switch with special way: long–long–long–short. ‘Long pressing’

means pressing and holding the tamper switch pressed for more than 1.5 s, while ‘short’ one means

pressing and holding the tamper switch pressed for the time between 0.1 s to 0.5 s. The pause be-

tween pressings must last from 0.1 s to 0.5 s.

73 www.bolid.com

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 95 96

Sin comentarios

Bolid Signal-10 Manual de usuario Pagina 73