Bolid Signal-10 Manual de usuario descargar pdf (Pagina 70)

Orion ISS

Programming the Signal-10 device for specific operations is implemented by setting or changing its

configuration parameters stored in the device non-volatile memory. To do this the Signal-10 device is

to be connected via one of the interface converters (PI-GR, S2000-PI, S2000-USB, or USB-RS485) to

a PC which is equipped with the program for configuring Orion system devices, UProg.exe.

After starting the program its main window will be output on the PC display. The UProg menu and its

toolbar are located at the top area of the window.

Select the Device → Read Device Configuration command (or press <Ctrl+F3>, or select

icon

from the toolbar). The Device Search window will be output to the display. Specify the number of the

logic COM port the Signal-10 is connecting to, and the UProg.exe will find all the devices connected

to that COM port of the PC. Then the list of all found devices along with their network addresses and

version numbers will be shown at the display.

Select the entry for the Signal-10 and press the Select button. The UProg will display the work win-

dow of the current Signal-10 settings. All the settings are presented by three tabs which are the Alarm

Loops, the Outputs, and the Keys tabs (see Figure 11).

Figure 11. UProg Work Window for Configuring the Signal-10

www.bolid.com 70

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 95 96

Sin comentarios

Bolid Signal-10 Manual de usuario Pagina 70